rp 450mm graphite electrode

Pubdate: 08-10 2021

RP 450mm graphite electrode handling details

rp 450mm graphite electrode

For the details of using the rp 450mm graphite electrode, you should know that the wet rp 450mm graphite electrode should be dried before use. Check whether the internal thread of the rp 450mm graphite electrode hole is complete.

When cleaning the surface and internal thread of the spare rp 450mm graphite electrode with compressed air, there should be no oil and water; avoid cleaning with steel wire or metal brush cloth. The connector must be carefully screwed into the rp 450mm graphite electrode hole of the spare rp 450mm graphite electrode, and the rp 450mm graphite electrode strap (graphite strap is recommended) is screwed into the rp 450mm graphite electrode hole at the other end of the spare rp 450mm graphite electrode .

When lifting the rp 450mm graphite electrode, the cushion should be soft to the bottom of the connector end of the spare rp 450mm graphite electrode assembly to prevent damage to the ground and connector; lift the ring extending from the hook to the spreader, and lift the rp 450mm graphite electrode It should be smooth to prevent the rp 450mm graphite electrode from falling off from end B or colliding with other fixing devices.

Next, hang the spare rp 450mm graphite electrode to the top of the rp 450mm graphite electrode to be connected, align it with the hole of the rp 450mm graphite electrode, and then slowly lower it; rotate the spare rp 450mm graphite electrode to make the spiral hook and the rp 450mm graphite electrode rotate and fall Together. When the rp 450mm graphite electrode is finally completely put down, do not use excessive force, otherwise the rp 450mm graphite electrode hole will damage the joint thread due to severe collision and other details. Finally, every effort should be made to ensure the pretreatment to ensure the stability of the graphite quality in the later stage.


Get the Quote

Send Mail Get Quote