rp 700 graphite electrode
rp 700 graphite electrode should be used strictly according to the instructions
The use of rp 700 graphite electrode in strict accordance with the instructions is not new to us. Its main component is graphite, which has become the best conductive material today. The rp 700 graphite electrode also needs to be operated strictly in accordance with the instructions during use.
First, the protective cap on the hole needs to be wiped to check the integrity of the thread of the rp 700 graphite electrode. On the premise of determining the integrity, the next step is to clean the internal thread of the hole and the surface of the spare rp 700 graphite electrode. Insert the connector into the hole of the rp 700 graphite electrode and at the same time connect the rp 700 graphite electrode strap to the other end. Put down the rp 700 graphite electrode. Be careful not to let the rp 700 graphite electrode collide with other fixtures.
Lift the spare rp 700 graphite electrode to the top of the rp 700 graphite electrode to be connected. When the end faces of the two rp 700 graphite electrodes are 10-20 mm apart, use compressed air to clean the exposed parts and joints of the end faces of the rp 700 graphite electrode again. It should be lighter to avoid damaging the threads and joints of the rp 700 graphite electrode hole. Just tighten the spare rp 700 graphite electrode. I need to remind everyone here that if the rp 700 graphite electrode is found to be damp, it must be dried.